Logpoint - Deploy - Install and Upgrade Logpoint
7.5.1
7.8.0 (latest)
7.8.1
7.7.1
7.6.1
7.4.2
7.3.1
7.2.4
7.1.3
7.0.2
Logpoint - Deploy - Install and Upgrade Logpoint
Version:
7.5.1
7.8.0 (latest)
7.8.1
7.7.1
7.6.1
7.4.2
7.3.1
7.2.4
7.1.3
7.0.2
×
Page Contents
Table of Content
Table of Content
¶
Install and Upgrade Logpoint
System Requirements for Logpoint
Hardware Requirements
Supported Browsers
Logpoint Release Cycle
Fresh Installation
Standard Configuration and Advanced Configuration
Standard Configuration
Advanced Configuration
Custom Configuration
Collector
Syslog Forwarder
Configuring network interfaces
Customizing storage partitions during installation
Patch Installation
Patch dependencies
Version specific requirements
Logpoint v7.5.0
Logpoint v7.3.0
Logpoint v7.0.0
Logpoint License
Trial Version
Licenses
Nodes
Adding a License
License Report
License Expiry
Connections required by Logpoint
Console Configuration
Creating an SSH key pair
From the UI
From the CLI
li-admin Commands
reboot
poweroff
change-ip
change-hostname
change-docker-bip
change-date
start-support
stop-support
repodir
ethbonding (LACP)
uploadpatch
route
tcpdump
iptables
mount
umount
pvcreate
vgextend
lvextend
resize2fs
zfs
zpool
gdisk
sgdisk
clean-opt
grub-install
mds-fs
lpfw-cli
View Help Texts for lpfw-cli Commands
Using lpfw-cli with iptables
Add new firewall rules
Remove firewall rules
View firewall rules for all three chains (INPUT, OUTPUT, and FORWARD)
View firewall rules for a particular chain (INPUT, OUTPUT, or FORWARD)
Flush firewall rules
Reload flushed firewall rules
View firewall policies for all three chains (INPUT, OUTPUT, or FORWARD)
View firewall policies for a particular chain (INPUT, OUTPUT, or FORWARD)
Using lpfw-cli with ipset
View all the IP Sets
View all the IP Sets in verbose mode
View information of a particular IP Set
Add a new IP to an IP Set
Remove an IP from an IP Set
LP Diag Commands
View Help Texts for LP Diag Commands
Enable LP Diag
Disable LP Diag
Check Status of LP Diag
ifup
ifdown
change_identifier
move-backup
fdisk
mkfs
rebackup
change-syslog-ssl-port
loadkeys
multipath
multipathd
fabric-auth
docker
change-ueba-network
change-snmpv3-passwd
change-snmpv3-key
toggle-acct
http-options
li-admin-pass-auth
enable-sshusers
disable-sshusers
vlock
netplan-apply
shenandoah
Netplan Migration in Logpoint
Network Configuration Using Netplan
Helpful?
Yes
No
We are glad this guide helped.
Please don't include any personal information in your comment
Contact Support
×
Navigation
next
Install and Upgrade Logpoint release/7.5.1 documentation
»
